Canon EOS C500 PL Manuale Utente Scaricare il pdf (Pagina 47)

Preparing Recording Media

To use double slot recording

1 Open the [Double Slot Rec] submenu.

[ 4K/2K/MXF Setup] > [Set CF Card Slot] > [Double Slot Rec]

2 Select [On] and then press SET.

NOTES

• When the bit rate is set to 50 Mbps (A 60), relay recording is not

available during slow motion recording.

• If a CF card becomes full during double slot recording, recording on both cards will stop. On the other hand, if

an error occurs with one of the cards, recording will continue on the other card.

• Double slot recording cannot be used with relay recording or slow & fast motion recording.

Checking the Available Recording Time for CF Cards

When the camera is in mode, the display on the upper left of the screen indicates which CF card slot is in

use and the available recording time (in minutes*) that remains on each CF card. The same information is

displayed in the rear panel. When the camera is in mode, the available recording time is displayed only in

the rear panel.

On the [Media] status screen (A 181), you can check the total space and used space of each recording media,

as well as the available recording time* on each CF card and the available number of photos on the SD card.

* The approximate available recording time is based on the current bit rate (A 60).

Recovering Data on the CF Card

Some actions, such as suddenly turning off the camera or removing the CF card while data is being recorded,

can cause data errors on the CF card. In such case, you may be able to recover the data on the CF card.

1 Insert the CF card with the data to be recovered into the camera.

2 When the screen prompts you to recover the data, select [OK] and then press SET.

3 When the confirmation message appears, press SET.

NOTES

• This procedure will delete clips shorter than 10 seconds in length. Additionally, up to 10 seconds will be

deleted from the end of clips on the CF card.

• In some cases, data may not be recovered, such as when the FAT32 file system is corrupted or the CF card is

physically damaged.

• While recording on a CF card, you can recover data from another CF card by inserting it into the other CF card

slot.

Operating modes:

[ 4K/2K/MXF Setup]

[Set CF Card Slot]

[Double Slot Rec]

[Off]

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 209 210

Nessun commento

Canon EOS C500 PL Manuale Utente Pagina 47