Canon CR-50 Guida di Installazione

♦ Please read this manual before operating this scanner.Operation & Maintenance Guide

102While lowering the down the OPEN lever, open the reading unit.3Remove the paper that has jammed.If the paper is jammed at the pickup area: Pull the

11The Scanner Does Not Turn ONCheck the following conditions, and take the appropriate action.The power switch is not in the ON position.Turn the swit

12When the Scanned Image Is Not NormalIf there is a problem with the scanned image (the image is not sharp or stripes appear), one of the following co

13MaintenanceThis chapter describes how to clean and maintain the scanner.Daily CleaningTo ensure high-quality image scanning, regularly clean your CR

14WARNINGDo not use flammable liquids to clean the scanner, including alcohol, benzene, or paint thinner.3Spin the rollers while wiping them clean wit

15IMPORTANTScratches on the scanning glass may cause marks on the images and could cause feeding errors. If there are scratches on the scanning glass,

163Gently close the Maintenance Cover until it clicks into place.Cleaning the Ink Jet NozzlesInk that collects around the ink jet nozzles may stain yo

173Remove the ink cartridge.For more information, see “Replacing the Ink Cartridge” on p. 18.4Use a dry cotton swab to wipe off any ink on the ink jet

18MaintenanceMake the following adjustments to maintain scanning quality.Replacing the Ink CartridgeThe ink cartridge needs to be replaced if the prin

194Push back the ink cartridge lock lever in the direction of the arrow in the diagram below, and pull out the ink cartridge by grasping the tab as sh

2 FCC REGULATIONS (For 120V model)Check Reader, Model M111101/M111102This device complies with Part 15 of the FCC Rules. Operation is subject to the

207Squeeze the Print Position Adjustment Lever and move it to adjust the print position.Top:50.5 mm (1.99") from the bottom edge of the documentM

21Adjusting the Separation Roller GapIf double feed should occur too often, adjust the Separation Roller gap according to the following procedure.IMPO

225Gently remove one of the sheets.6Adjust the gap between the feeding roller and the separation roller to optimum width.While one sheet remains in pl

23IndexAAdjusting the Print Position... 20Amount loaded ...

CANON ELECTRONICS INC.1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892, JAPANCANON U.S.A. INC.ONE CANON PLAZA, LAKE SUCCESS, NY 11042, U.S.A.CANON

3 Trademarks• Canon and the Canon logo are registered trademarks of Canon Inc. in the United States and may also be trademarks or registered trademar

4INTRODUCTIONThank you for purchasing the Canon Check Reader CR-50/80.Please read this manual thoroughly before using the machine in order to familiar

5Table of ContentsINTRODUCTION...4Manuals for the CR-50/80 ...

6Document Feeding and ScanningThis chapter describes precautions regarding documents that can be handled on this scanner and scanning operations.Docum

7Placing DocumentsNote the following points when placing documents on the scanner.• Place the front of the document toward you.• A maximum of 50 docum

83Load the documents with their front sides facing right and with their edges flush against the document load mark.4Adjust the Eject Stopper in accord

9TroubleshootingThis chapter describes the problems that might occur in the CR-50/80, and how to remedy them.When the Scanner Is Not RecognizedThe fol