Canon Mk2500 Guida Utente Scaricare il pdf (Pagina 155)

5

Appendices

Part 6

6.5

List of Function

Clear tube reverse

*About the Printing Performed with the Segment Length Specied

The following table summarizes the specications to conform to when printing characters

with “Normal” specified on the

Plate Printing Area selection display and a value less than 8.5 mm specified on the Seg Length selection

display:

Media

Specificationsappliedwhenthe segment length is specified to a value less than 8.5 mm

Plate A segment length can be specied, but only [Centered] can be specied as the character alignment.

Label A segment length can be specied, but only [Centered] can be specied as the character alignment.

* Characters may not be centered when “Half Cut” is set to “On”.

When the label is half cut with the segment length of 3.5mm or less, consider the following:

• Use the 9mm/12mm-width label.

• Cut depth adjustment is required. ( page 130)

Tube

4mm I.D. Strip

Clear tube

Heat shrink tube

Wrap around tape

If you specify a segment length, it is automatically changed to “Automatic” to maintain the print quality

during actual printing.

(The left and right margin become 2.0 mm or wider respectively.)

1 2 ... 150 151 152 153 154 155 156 157 158

Nessun commento

Canon Mk2500 Guida Utente Pagina 155